Flex Seal Products 14 oz. Black FLEX SEAL Liquid Rubber Spray Sealant

FLEX SEAL is actually liquid rubber in a can! It sprays out as a thick liquid, seeps into cracks and holes and dries to a watertight, flexible, rubberized coating. Flex Seal coats, seals, protects and will stop leaks fast!

It's like ...HANDYMAN IN A CAN®

FLEX SEAL® has many advantageous applications and uses, that when applied correctly, can last for many years. The most common uses for Flex Seal are listed below:

• Fix leaky roofs, gutters, and downspouts
• Repair RV'S, campers, and mobile homes
• Repair skylights
• Vent Pipes
• For roof drip edges and flashings
• Leaky or broken hose and PVC pipe repairs
• To seal or repair windowsills
• For A/C drip pans, portable A/C units, duct work, and chimneys
• On boats and other personal watercrafts
• For bird baths, ponds, and fountains
• Flat, metal, rubberized and granulated roof repairs and leaks
• Foundations, gravel stops, asphalt shingles, and overlapped seams
• And, much more!

Flex Seal will work on:

Wood, metal, tile, concrete, masonry, fabric, glass, plastic, aluminum, porcelain, dry wall, rubber, cement, some vinyls and so much more!

*Flex Seal may not be compatible with all plastics, vinyls, or rubbers.

Directions:

1. Read entire can. Wear face and eye protection, protective gloves, and clothing. Make sure the surface is clean, dry, and free of grease, oil, and dirt. Shake well. Spray 8" to 12" from surface, using an even, sweeping motion. Apply multiple, even coats until ALL cracks and holes have been filled.
2. IMPORTANT: Allow 24 to 48 hours to dry before applying another coat.
3. Let it dry completely. (It usually takes up to 24 to 48 hours to fully cure.)

*Use Flex Seal ONLY in a well-ventilated area. When using inside, prevent vapor build-up by opening doors and windows. Ensure fresh air entry during application and drying.

*Do not use near heat, sparks, pilot lights or other sources of ignition.

FLEX TIPS:

• Spray a larger area than area where the leak is and feather the edges. For best results, apply multiple coats rather than one thick coat and use at can temperatures above 60ºF.
• Make sure Flex Seal has filled ALL cracks and holes and is FULLY CURED before testing product. If light can pass through, apply additional coats.