Gorilla Clear Grip® is a flexible, fast-setting, crystal clear contact adhesive that creates a strong, permanent bond. Gorilla Clear Grip® is paintable and waterproof making it great for projects both inside and out! Build, Repair, Craft™

Directions for Use

All surfaces should be clean and free of dirt, grease and oil. Best if used between 50°F and 90°F. Clear Grip® should only be used in a well ventilated area.

1. Apply adhesive to each surface to be bonded.

To maximize bond strength: Wait approximately two minutes for adhesive to partially dry before joining surfaces.

2.Press surfaces firmly together.

NOTE: Bond forms immediately and can be difficult to reposition.

Cure Time

Allow for a minimum of 24 hours for full cure. Cure time may increase with lower temperatures and when used on non-porous surfaces.

Storage Tips

After each use, wipe nozzle with a dry cloth and tightly replace cap. Store in a cool, dry location. Tip: For easier re-opening, apply a thin coat of petroleum jelly to the threads before replacing cap. Store away from children and animals.

Clean-up

Wipe uncured adhesive with a dry cloth and clean with acetone, isopropyl alcohol, or citrus based solvents according to manufacturer's instructions. Cured adhesive may be removed by scraping from surface.

Paintable

When fully cured.

*NOTE: Not recommended for use on polystyrene, polypropylene or polyethylene products. Not for use on food contact surfaces. Do not dry clean. May cause damage to finished surfaces.